東華大學圖書館 |

語系: 繁體中文

說明(常見問題)

回圖書館首頁

手機版館藏查詢

登入

回首頁

切換: 標籤 | MARC模式 | ISBD

Dynamic behavior of acoustic metamat...

Manimala, James Mathew.

FindBook

Google Book

Amazon

博客來

Dynamic behavior of acoustic metamaterials and metaconfigured structures with local oscillators.

紀錄類型:	書目-電子資源 : Monograph/item
正題名/作者:	Dynamic behavior of acoustic metamaterials and metaconfigured structures with local oscillators./
作者:	Manimala, James Mathew.
面頁冊數:	217 p.
附註:	Source: Dissertation Abstracts International, Volume: 76-02(E), Section: B.
Contained By:	Dissertation Abstracts International76-02B(E).
標題:	Engineering, Aerospace. -
電子資源:	http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3636383
ISBN:	9781321179866

Dynamic behavior of acoustic metamaterials and metaconfigured structures with local oscillators.
Manimala, James Mathew.

Dynamic behavior of acoustic metamaterials and metaconfigured structures with local oscillators. - 217 p.

Source: Dissertation Abstracts International, Volume: 76-02(E), Section: B.

Thesis (Ph.D.)--Purdue University, 2014.

This item must not be sold to any third party vendors.

Dynamic behavior of acoustic metamaterials (AM) and metaconfigured structures (MCS) with various oscillator-type microstructures or local attachments was investigated. AM derive their unusual elastic wave manipulation capabilities not just from material constituents but more so from engineered microstructural configurations. Depending on the scale of implementation, these "microstructures" may be deployed as microscopic inclusions in metacomposites or even as complex endo-structures within load-bearing exo-structures in MCS. The frequency-dependent negative effective-mass exhibited by locally resonant microstructures when considered as a single degree of freedom system was experimentally verified using a structure with an internal mass-spring resonator. AM constructed by incorporating resonators in a host material display spatial attenuation of harmonic stress waves within a tunable bandgap frequency range. An apparent damping coefficient was derived to compare the degree of attenuation achieved in these wholly elastic AM to equivalent conventionally damped models illustrating their feasibility as stiff structures that simultaneously act as effective damping elements. Parametric studies were performed using simulations to design and construct MCS with attached resonators for dynamic load mitigation applications. 98% payload isolation at resonance (7 Hz) was experimentally attained using a low-frequency vibration isolator with tip-loaded cantilever beam resonators. Pendulum impact tests on a resonator stack substantiated a peak transmitted stress reduction of about 60% and filtering of the resonator frequencies in the transmitted spectrum. Drop-tower tests were done to gauge the shock mitigation performance of an AM-inspired infrastructural building-block with internal resonators. Proof-of-concept experiments using an array of multifunctional resonators demonstrate the possibility of integrating energy harvesting and transducer capabilities. Stress wave attenuation in locally dissipative AM with various damped oscillator microstructures was studied using mechanical lattice models. The presence of damping was represented by a complex effective-mass. Analytical transmissibilities and numerical verifications were obtained for Kelvin-Voigt-type, Maxwell-type and Zener-type oscillators. Although peak attenuation at resonance is diminished, broadband attenuation was found to be achievable without increasing mass ratio, obviating the bandgap width limitations of locally resonant AM. Static and frequency-dependent measures of optimal damping that maximize the attenuation characteristics were established. A transitional value for the excitation frequency was identified within the locally resonant bandgap, above which there always exists an optimal amount of damping that renders the attenuation for the dissipative AM greater than that for the locally resonant case. AM with nonlinear stiffnesses were also investigated. For a base-excited two degree of freedom system consisting of a master structure and a Duffing-type oscillator, approximate transmissibility was derived, verified using simulations and compared to its equivalent damped model. Analytical solutions for dispersion curve shifts in nonlinear chains with linear resonators and in linear chains with nonlinear oscillators were obtained using perturbation analysis and first order approximations for cubic hardening and softening cases. Amplitude-activated alterations in bandgap width and the possibility of phenomena such as branch curling and overtaking were observed. Device implications of nonlinear AM as amplitude-dependent filters and direction-biased waveguides were examined using simulations.

ISBN: 9781321179866Subjects--Topical Terms:

1018395
Engineering, Aerospace.

Dynamic behavior of acoustic metamaterials and metaconfigured structures with local oscillators.
LDR:04683nmm a2200301 4500 001 2057031
005 20150630121441.5
008 170521s2014 ||||||||||||||||| ||eng d
020 $a 9781321179866
035 $a (MiAaPQ)AAI3636383
035 $a AAI3636383
040 $a MiAaPQ $c MiAaPQ
100 1 $a Manimala, James Mathew. $3 3170838
245 1 0 $a Dynamic behavior of acoustic metamaterials and metaconfigured structures with local oscillators.
300 $a 217 p.
500 $a Source: Dissertation Abstracts International, Volume: 76-02(E), Section: B.
500 $a Adviser: Chin-Teh Sun.
502 $a Thesis (Ph.D.)--Purdue University, 2014.
506 $a This item must not be sold to any third party vendors.
520 $a Dynamic behavior of acoustic metamaterials (AM) and metaconfigured structures (MCS) with various oscillator-type microstructures or local attachments was investigated. AM derive their unusual elastic wave manipulation capabilities not just from material constituents but more so from engineered microstructural configurations. Depending on the scale of implementation, these "microstructures" may be deployed as microscopic inclusions in metacomposites or even as complex endo-structures within load-bearing exo-structures in MCS. The frequency-dependent negative effective-mass exhibited by locally resonant microstructures when considered as a single degree of freedom system was experimentally verified using a structure with an internal mass-spring resonator. AM constructed by incorporating resonators in a host material display spatial attenuation of harmonic stress waves within a tunable bandgap frequency range. An apparent damping coefficient was derived to compare the degree of attenuation achieved in these wholly elastic AM to equivalent conventionally damped models illustrating their feasibility as stiff structures that simultaneously act as effective damping elements. Parametric studies were performed using simulations to design and construct MCS with attached resonators for dynamic load mitigation applications. 98% payload isolation at resonance (7 Hz) was experimentally attained using a low-frequency vibration isolator with tip-loaded cantilever beam resonators. Pendulum impact tests on a resonator stack substantiated a peak transmitted stress reduction of about 60% and filtering of the resonator frequencies in the transmitted spectrum. Drop-tower tests were done to gauge the shock mitigation performance of an AM-inspired infrastructural building-block with internal resonators. Proof-of-concept experiments using an array of multifunctional resonators demonstrate the possibility of integrating energy harvesting and transducer capabilities. Stress wave attenuation in locally dissipative AM with various damped oscillator microstructures was studied using mechanical lattice models. The presence of damping was represented by a complex effective-mass. Analytical transmissibilities and numerical verifications were obtained for Kelvin-Voigt-type, Maxwell-type and Zener-type oscillators. Although peak attenuation at resonance is diminished, broadband attenuation was found to be achievable without increasing mass ratio, obviating the bandgap width limitations of locally resonant AM. Static and frequency-dependent measures of optimal damping that maximize the attenuation characteristics were established. A transitional value for the excitation frequency was identified within the locally resonant bandgap, above which there always exists an optimal amount of damping that renders the attenuation for the dissipative AM greater than that for the locally resonant case. AM with nonlinear stiffnesses were also investigated. For a base-excited two degree of freedom system consisting of a master structure and a Duffing-type oscillator, approximate transmissibility was derived, verified using simulations and compared to its equivalent damped model. Analytical solutions for dispersion curve shifts in nonlinear chains with linear resonators and in linear chains with nonlinear oscillators were obtained using perturbation analysis and first order approximations for cubic hardening and softening cases. Amplitude-activated alterations in bandgap width and the possibility of phenomena such as branch curling and overtaking were observed. Device implications of nonlinear AM as amplitude-dependent filters and direction-biased waveguides were examined using simulations.
590 $a School code: 0183.
650 4 $a Engineering, Aerospace. $3 1018395
650 4 $a Applied Mechanics. $3 1018410
650 4 $a Engineering, Materials Science. $3 1017759
690 $a 0538
690 $a 0346
690 $a 0794
710 2 $a Purdue University. $b Aeronautics and Astronautics. $3 1035670
773 0 $t Dissertation Abstracts International $g 76-02B(E).
790 $a 0183
791 $a Ph.D.
792 $a 2014
793 $a English
856 4 0 $u http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3636383