東華大學圖書館 |

Language: English

Help

回圖書館首頁

手機版館藏查詢

Back

Switch To: Labeled | MARC Mode | ISBD

Kinetics of nano-sized silicon nitri...

Vongpayabal, Panut.

Linked to FindBook

Google Book

Amazon

博客來

Kinetics of nano-sized silicon nitride powder synthesis via ammonolysis of silicon oxide vapor.

Record Type:	Electronic resources : Monograph/item
Title/Author:	Kinetics of nano-sized silicon nitride powder synthesis via ammonolysis of silicon oxide vapor./
Author:	Vongpayabal, Panut.
Description:	182 p.
Notes:	Source: Dissertation Abstracts International, Volume: 64-08, Section: B, page: 3944.
Contained By:	Dissertation Abstracts International64-08B.
Subject:	Engineering, Chemical. -
Online resource:	http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3103578

Kinetics of nano-sized silicon nitride powder synthesis via ammonolysis of silicon oxide vapor.
Vongpayabal, Panut.

Kinetics of nano-sized silicon nitride powder synthesis via ammonolysis of silicon oxide vapor. - 182 p.

Source: Dissertation Abstracts International, Volume: 64-08, Section: B, page: 3944.

Thesis (Ph.D.)--Oregon State University, 2003.

An 89 mm-diameter vertical tubular-flow reactor was used to study the kinetics of nano-sized silicon nitride powder synthesis via the ammonolysis of SiO vapor at temperatures ranging from 1300°C to 1400°C. The SiO generation rate was controlled by adjusting the mass of SiO particles initially charged in the SiO generator, when the flow rate of carrier gas argon was maintained unchanged. The molar feed ratio of NH3/SiO at the feeder outlets was maintained in large excess of the stoichiometric ratio ranging from about 100 to 1200 mol NH3/mol SiO.Subjects--Topical Terms:

1018531
Engineering, Chemical.

Kinetics of nano-sized silicon nitride powder synthesis via ammonolysis of silicon oxide vapor.
LDR:03188nmm 2200301 4500 001 1855263
005 20040624070205.5
008 130614s2003 eng d
035 $a (UnM)AAI3103578
035 $a AAI3103578
040 $a UnM $c UnM
100 1 $a Vongpayabal, Panut. $3 1943080
245 1 0 $a Kinetics of nano-sized silicon nitride powder synthesis via ammonolysis of silicon oxide vapor.
300 $a 182 p.
500 $a Source: Dissertation Abstracts International, Volume: 64-08, Section: B, page: 3944.
500 $a Adviser: Shoichi Kimura.
502 $a Thesis (Ph.D.)--Oregon State University, 2003.
520 $a An 89 mm-diameter vertical tubular-flow reactor was used to study the kinetics of nano-sized silicon nitride powder synthesis via the ammonolysis of SiO vapor at temperatures ranging from 1300°C to 1400°C. The SiO generation rate was controlled by adjusting the mass of SiO particles initially charged in the SiO generator, when the flow rate of carrier gas argon was maintained unchanged. The molar feed ratio of NH3/SiO at the feeder outlets was maintained in large excess of the stoichiometric ratio ranging from about 100 to 1200 mol NH3/mol SiO.
520 $a The SiO-NH3 reaction yielded two different morphologies of silicon nitride products at different locations in the reactor: nano-sized powder with an averaged particle size of about 17 nm and whiskers with a variety of shapes and diameters of a few micrometers. Nano-sized powder was the dominant product in the system and its mass fraction over the total product varied from 83% to 100%, depending on operating conditions.
520 $a The contact pattern between SiO vapor and NH3 inside the reacting zone was one of the most important parameters that affected Si3N 4 formation kinetics. When a small single tube was employed for feeding NH3 (flow condition J), a highest efficiency of SiO vapor utilization was achieved at a high level of SiO conversion. The SiO conversion increased from 72% to 91% with an increase in the residence time from 0.17 s to 0.69 s, indicating that the SiO-NH3 reaction was not instantaneous but was relatively fast.
520 $a When the molar feed rate of NH3 was 2—3 orders of magnitude greater than that of SiO vapor, the rate of nano-sized powder synthesis was independent of NH3 concentration and of first order with respect to the SiO concentration. A pseudo-first order rate expression was proposed, and the apparent activation energy was determined to be 180 kJ/mol.
520 $a The gas flow in the reactor simulated with a computational fluid dynamic program revealed that whisker formed where the stagnation of gas flow formed. A power law rate expression for whisker formation was proposed based on measured rates of whisker formation and simulation-predicted reactant-gas concentrations.
590 $a School code: 0172.
650 4 $a Engineering, Chemical. $3 1018531
690 $a 0542
710 2 0 $a Oregon State University. $3 625720
773 0 $t Dissertation Abstracts International $g 64-08B.
790 1 0 $a Kimura, Shoichi, $e advisor
790 $a 0172
791 $a Ph.D.
792 $a 2003
856 4 0 $u http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3103578