東華大學圖書館 |

Language: English

Help

回圖書館首頁

手機版館藏查詢

Back to Search results for [ null ]

Switch To: Labeled | MARC Mode | ISBD

Pure fluid and binary mixture transi...

Gebbie, James George.

Linked to FindBook

Google Book

Amazon

博客來

Pure fluid and binary mixture transients of a heat pump equipped with a distillation column: An experimental and numerical investigation.

Record Type:	Language materials, printed : Monograph/item
Title/Author:	Pure fluid and binary mixture transients of a heat pump equipped with a distillation column: An experimental and numerical investigation./
Author:	Gebbie, James George.
Description:	336 p.
Notes:	Adviser: Michael K. Jensen.
Contained By:	Dissertation Abstracts International63-12B
Subject:	Engineering, Mechanical -
Online resource:	http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3072052
ISBN:	0493949275

Pure fluid and binary mixture transients of a heat pump equipped with a distillation column: An experimental and numerical investigation.
Gebbie, James George.

Pure fluid and binary mixture transients of a heat pump equipped with a distillation column: An experimental and numerical investigation. - 336 p.

Adviser: Michael K. Jensen.

Thesis (Ph.D.)--Rensselaer Polytechnic Institute, 2002.

*This dissertation is a multimedia document (contains text and other applications not available in printed format)

ISBN: 0493949275Subjects--Topical Terms:

1260257
Engineering, Mechanical

Pure fluid and binary mixture transients of a heat pump equipped with a distillation column: An experimental and numerical investigation.
LDR:03105nam 2200301 a 45 001 936701
005 20110510
008 110510s2002 eng d
020 $a 0493949275
035 $a (UnM)AAI3072052
035 $a AAI3072052
040 $a UnM $c UnM
100 1 $a Gebbie, James George. $3 1260534
245 1 0 $a Pure fluid and binary mixture transients of a heat pump equipped with a distillation column: An experimental and numerical investigation.
300 $a 336 p.
500 $a Adviser: Michael K. Jensen.
500 $a Source: Dissertation Abstracts International, Volume: 63-12, Section: B, page: 6052.
502 $a Thesis (Ph.D.)--Rensselaer Polytechnic Institute, 2002.
520 $a *This dissertation is a multimedia document (contains text and other applications not available in printed format)
520 $a The transient behavior of a heat pump equipped with a distillation column has been experimentally and numerically investigated. An experimental water-to-water heat pump system was tested using pure R32, and using a 30/70% by mass mixture of R32/134a. A set (24 factorial design) of experiments were conducted with the pure fluid and with the mixture. The factors, each with a high and low setting, were: sump heater power, evaporator heat transfer fluid mass flow rate, condenser heat transfer fluid mass flow rate, and compressor speed. Additionally, a set of computer models were written to predict the steady-state behaviors of the compressor, condenser, and evaporator. The models were validated using the experimental data, then they were used to test whether or not it might be possible to model the transient performance of these components on a quasi-steady basis.
520 $a Changes in startup transient behavior due to the four factors were not always as expected. An increase in sump heater power did make the pure fluid transients more rapid, but the mixture transient behavior was relatively unchanged. The mixture tests differed in that increases in sump heater power increased not only the mass introduction rate to the refrigerant loop, but also the effectiveness of the distillation column. Changes in end-of-test capacities due to the four factors were generally as expected. A complete discussion of the cause and effects of changes in transient and end-of-test behavior, due to the factorial changes, is presented
520 $a The steady-state compressor, condenser, and evaporator models generally predicted end-of-test performance within 5%. Good agreement was also obtained when the models were used to predict transient performance on a quasi-steady basis. On average, agreement between the models and the transient data was within 5% for times greater than 10 minutes after startup. This indicates that a quasi-steady system model, integrating all heat pump components, should predict transient data reasonably well.
590 $a School code: 0185
650 $a Engineering, Mechanical $3 1260257
690 $a 054
710 2 $a Rensselaer Polytechnic Institute $3 1260535
773 0 $t Dissertation Abstracts International $g 63-12B
790 $a 018
790 1 $a Jensen, Michael K., $e adviso
791 $a Ph.D
792 $a 200
856 4 0 $u http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=3072052